PU Leather Phone Case with Card Slots

Product Detailed Description

A PU leather cover shaped to wrap the phone in a single piece, the back panel curving into a raised rim around the edges. Inside, a polyester sheet is bonded to the shell, separating the phone from the PU. The rear carries a camera opening and flat card slots stitched along the inner wall, where you tuck a transit pass or badge. You stretch the rim over a corner, slide the body onto the phone, and the shell settles into place. On a retail pegboard strip the case sits flat, the card-slot side facing outward so the buyer sees the feature before picking it up.

• A round opening cut through the rear lets you point and shoot without removing the cover from the phone
• Card slots lie flat against the inner wall, holding a transit pass out of sight from the outside surface
• The polyester sheet faces the phone back, the PU faces outward, and the materials meet only along the folded edge seam
• You flex a corner of the rim outward, hook the phone body in, and press the opposite corner to seat it
• Before fitting a new phone, you wipe the polyester lining with a dry cloth to lift any dust trapped at the corner seam